Panasonic WJ-SX 150A Operating Instructions Manual page 56

5.Click on the OK button in Version confirmation mode win-
dow.
Note: If the selector settings are wrong when you do
Step 5, the following message will appear to notify
that version confirmation was failed.
In this case, confirm the connections and do Step 1 to 5
again.
6. Turn off the Master unit.
7. Set the mode selector as shown in the Firmware update
mode window.
8. Turn on the unit again.
9. Click on the OK button. The unit will be set to the
firmware update mode.
10. The Program Writer for SX150A window will be dis-
played.
When you power on the matrix switcher and the system
becomes ready for update, the following message will
appear on the PC screen.
" FIRMWARE UPLOAD START! WAIT..."
59
11. Wait until the following message appears.
" SDRAM INITIALIZE COMPLETED.START LOAD-
ING..."
12. Insert the supplied CD-ROM into the PC.
13. Click on the "Browse..." button to select a .mot file.
The file is located in the following directory.
E: \PWriter\sx150A_v
(E is the CD-ROM drive and
For example, V111 means Version 1.11.)
14. Make sure that the new software version is displayed in
the Transfer File box.
15. Press the Transfer button.
16. A message window will appear to ask you if it is OK to
overwrite the software. After confirmation, click on "OK".
The .mot file will be copied from the CD-ROM to the
matrix switcher.
You can confirm the status by viewing messages.
(1) " LOAD OK...": The copy is finished.
(2) " NOW ERASING...": Data is being erased
from the flash memory.
(3) " NOW WRITING...": New data is being
written in the flash memory.
(4) " COMPLETED!!": The flash-memory
writing is finished.
Notes:
• Copying takes approx. 7 minutes.
• Avoid disconnecting or powering off the PC and the
matrix switcher. It may cause trouble.
17. After " COMPLETED!!" is displayed, power off
the matrix switcher.
18. Set the mode selector of the matrix switcher as follows.
MODE
ON
1 2 3 4
19. Display the matrix switcher's SETUP MENU. (Refer to
the matrix switcher's operating instructions.)
20. Make sure that the version of the matrix switcher is dis-
played in SETUP MENU. That shows the software
update has been successfully executed.
.mot
is the software version.