Program Preset Position; Call Preset Position - Panasonic WJ-SX 150A Operating Instructions Manual

Program Preset Position

1. Select the desired monitor and camera. (Refer to p. 106
Monitor Selection and p. 107 Camera Selection.)
2. To move the camera to the position to be preset, move
the joystick and press the lens control buttons.
3. To select the desired preset position number, press the
numeric buttons. (1 to 64)
4. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
5. Press the CALL PRESET button while holding down the
SHIFT button to save a preset position of the selected
camera.
TOUR SEQ
NEXT
MON STATUS
PAUSE
PAUSE SEQUENCE
MON (ESC)
MON LOCK
SHIFT
Notes:
• If the entered position number has stored the previ-
ous preset position, it will be overwritten by the new
one.
• SETUP MENU
Console can configure each operator's pan/tilt con-
trol. (Refer to p. 76 OPERATOR REGISTRATION or
p. 90 Operator Registration.)
109
CALL
PRESET
T&D CAM ID EVENT
AUX1 OFF AUX1 ON PROGRAM
STILL
PRESET
ALL
AUTO PAN
AUX2 OFF AUX2 ON
EL-ZOOM
ALM H VLD H SYS S
CAM FUNC
DEF OFF DEF ON
CAM (SET) CLEAR
LOG OUT
WIPER
MULTI SCREEN SEL
and WJ-SX150A Administrator

Call Preset Position

1. Select the desired monitor and camera. (Refer to p. 106
Monitor Selection and p. 107 Camera Selection.)
2. To select the desired preset position number, press the
numeric buttons. (1 to 64)
3. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
4. Press the CALL PRESET button to move to the preset
position of the selected camera on the active monitor.
T&D CAM ID
AUX1 OFF
STILL
MON STATUS ALL
AUX2 OFF
EL-ZOOM
ALM H VLD H
DEF OFF
SEQUENCE
MON (ESC)
MON LOCK
MULTI SCREEN SEL
Notes:
• To use the above function, you must set the preset
position number for the camera.
• If you press no numeric buttons or the button 0 in
Step 2, the camera will move to the home position.
CALL
PRESET
EVENT
AUX1 ON PROGRAM
PRESET
AUTO PAN
AUX2 ON
SYS S
CAM FUNC
DEF ON
CAM (SET)
CLEAR
LOG OUT
WIPER