Panasonic WJ-HD100 Operating Instructions Manual page 8

#2 2 Status Out Terminal
These terminals supply the following status information:
PLAY OUT, REC OUT, AUTO OFF OUT, DISK END
OUT.
AUTO OFF OUT: AUTO OFF OUT signal turns active
(active when low), and playback or recording stops
when a temperature error is detected inside the unit.
Turn the power off and wait for a while until you turn it
on again to reset the error.
#3 3 Series Record Terminal
Connect these terminals when using multiple units in
series or loop connection.
#4 4 Alarm Terminal
These terminals supply and receive the following alarm
related information: ALARM RECALL, ALARM OUT,
ALARM RECOVER OUT, ALARM RESET IN, ALARM IN.
#5 5 Cooling Fan
Do not block the air flow of this cooling fan through the
openings on both sides of the top cover to prevent the
appliance from overheating.
#6 6 Power Switch [POWER ON OFF]
Turns the power on and off. The OPERATE indicator on
the front panel lights while the power switch is turned
on.
#7 7 Signal Ground [SIGNAL GND]
Connect with the terminals of other devices as neces-
sary to avoid grounding loop and noise.
#8 8 Power Cord
8