Panasonic WJ-HD100 Operating Instructions Manual page 28

2. Rotate the JogDial to select ON or OFF.
ON: Buzzer beeps while alarm is active.
OFF: Buzzer does not beep.
Motion Detector Setup
306 VMD SETUP
A VMD or Video Motion Detector senses changes in the
video signals within a preset area and supplies alarm out-
put. When a change is detected, the recorder starts
recording. The detection sensitivity and area are selected
on this menu.
ALARM SETUP
REC MODE
REC RATE
REC QUALITY
DURATION
ALARM BUZZER
VMD SETUP
1. Move the cursor to VMD SETUP with the up [ ] or
down [ ] button.
2. Rotate the JogDial to select the desired parameter, then
press the JogDial. The default is OFF.
[LOW ]: Low sensitivity motion detection is enabled.
]: Medium sensitivity motion detection is
[MID
enabled.
[HIGH ]: High sensitivity motion detection is enabled.
[OFF]: Motion detection is disabled.
The area setup window appears with an asterisk when
other than OFF is selected. The asterisk represents the
upper-left or bottom-right of the detection area. The
division lines are not actually displayed on the monitor.
28
SF- 12H
15FPS
10(1-10)
10S
ON
OFF
Notes:
• VMD should be used with an ordinary camera input to
the unit. Select [OFF] to avoid useless VMD when a
video multiplexer or combination camera supplies the
input to the unit.
• Make sure that the date and status displays are not
located within the motion detection area on the monitor.
Otherwise the motion detector could be misled.
• Set the ALARM SUSPEND to ON with the LCD button
when VMD is unnecessarily activated during the VMD
setup.
• VMD does not function while playing back.
3. Set the upper-left end of the detection area. Move the
asterisk to the right or left with the JogDial, and up or
down by pressing the up [ ] or down [ ] button.
REW/FF
/
STEP
/
PUSH PAUSE
•
/
4. Press the JogDial to enter the upper-left end of the
detection area. The asterisk position is highlighted.
5. Set the bottom-right end of the detection area similar to
steps 3 and 4 above.
6. Press the JogDial. The area is highlighted.
Up to 4 areas can be selected. These may partially
overlap. Repeat steps 3 to 6 to select more areas. To
unselect an area, move the cursor to the upper-left end
of the area, and then press the JogDial.
q
SET
/
e
w
r