S+S Regeltechnik RYMASKON 700 Series Operating Instructions Manual page 28

Operating instructions
RYMASKON ® 700 - BACnet
®
RYMASKON 700 - Modbus
RYMASKON 700 Series | Parameter Table | Status: 04.04.2022 (EN)
Mode Icon
Off Icon
Humidity Display
CO2 Display
Show Unit Swap
Sensor 1 text
Sensor 2 text
Sensor 3 text
Setpoint Mode
Disable ECO-Button
S+S REGELTECHNIK GMBH | THURN-UND -TA XIS - STR. 22 | D -90411 NÜRNBERG | GERMANY | FON +49 ( 0 ) 911 51947- 0 | w w w.S p lusS.de
Enable and selection of the plain text button for
the operating mode
Auto: Auto
Htg: Heizen
Clg: Kühlen
Fan: Lüften
Enable of the Off icon
Enable of the RH display
(devices with RH option)
The value is displayed in the small action circle.
Enable of CO2 display
(devices with CO2 option)
The value is displayed in the small action circle.
Enable of icon for switching between degrees
Celsius and degrees Fahrenheit on the main
screen
Designation of sensor 1 (RI1/network)
Default 0 = Disabled
NOTE: If disabled, no text and measurement
is displayed for sensor 1.
Designation of sensor 2 (RI2/network)
Default 0 = Disabled
NOTE: If disabled, no text and measurement
is displayed for sensor 2.
Designation of sensor 3 (internal/network)
Default 1 = Room
NOTE: If disabled, no text and measurement
is displayed for sensor 3.
(0) Temperature: Target temperature display in
°C or °F
(1) Percentage: Setpoint display in percent
(2) None: The measurement of sensor 3 is
displayed in the circle instead of the target
temperature. If no other measurement is
displayed in the action circle, instead of the
action circle a gearwheel is displayed as
suggestion to call up the secondary screen.
(3) Temperature Rel.: Display of the relative
target temperature adaptation (+/-)
The Setpoint Limit Mode must be set to
Relative
(4) State Select: Change to setpoint in whole
numbers, display of "Min"/"Max" if
minimum/maximum value reached
Enable of ECO icon for user-side cancellation of
ECO mode
28
0 = Disable (Default)
1 = Htg/Clg
2 = Htg/Clg/Fan
3 = Auto/Htg/Clg
4 = Auto/Htg/Clg/Fan
5 = Auto/Htg/Fan
6 = Auto/Clg/Fan
0 = Disabled (Default)
1 = Enabled
0 = Disabled
1 = Enabled (Default)
0 = Disabled
1 = Enabled (Default)
0 = Disabled (Default)
1 = Eanabled
0 = Disabled
1 = Room
2 = Floor
3 = Outside
4 = Zone 1
5 = Zone 2
6 = Zone 3
7 = Bathroom
8 = Sauna
9 = Bedroom
10 = Kitchen
11 = Cooler
12 = Flow
13 = Hot Water
14 = Tank
15 = Pool
16 = Cabin
0 = Temperature (Default)
1 = Percentage
2 = None
3 = Temperature Rel.
4 = State Select