Configuring The Parameters - S+S Regeltechnik RYMASKON 700 Series Operating Instructions Manual

Operating instructions
RYMASKON ® 700 - BACnet
®
RYMASKON 700 - Modbus
CONFIGURING
THE PARAMETERS
Setting Mode
for changing parameters
directly on the display
Parameter Groups
TAP TO SELECT THE
SETTINGS GROUP
S+S REGELTECHNIK GMBH | THURN-UND -TA XIS - STR. 22 | D -90411 NÜRNBERG | GERMANY | FON +49 ( 0 ) 911 51947- 0 | w w w.S p lusS.de
Tapping the cogwheel icon on the auxiliary screen
activates setting mode in order to configure accessible
parameters directly on the display.
Access requires entry of a PIN code
('Maintenance Code', default: 6666).
NOTE:
The PIN code can be changed in the settings
(System - Maintenance Code).
Note the new PIN for security.
Parameter Groups
Control Settings
Inputs
Operating Modes
Display
System
After successfully entering the PIN Code, the 'Parameter Groups 'Parameter Groups' are displayed.
Tapping the arrow key accesses the list of the subordinate 'Input Settings'.
The plain text here acts as a button for entry of the parameter settings.
For description and input area, see parameter table on the following pages!
NOTE:
Changed communication parameters are activated when setting mode is exited –
the unit performs a soft reset. Alternatively, the new settings can also be activated
by switching the unit off and on again.
Saving the parameters
The configuration parameters are stored in the non-volatile memory of the unit.
After changing the configuration via the display, the new parameters are saved
when the unit returns to the main screen.
If the changes were made via the bus (Modbus), the parameter for updating
the non-volatile memory is required in order to force saving.
If configuration takes place via the display, the parameters are saved after an
expiry time or when the settings menu is closed.
24
Input Settings
Sensor 1 Source
Hardware
Sensor 2 Source
Network
Sensor 3 Source
Hardware
Digital Input Mode
Close for ECO
Fig.18
Maintenance Code
Enter Code
6666
7 8 9
4 5 6 -
1 2 3
Esc
0
Del OK
Fig.17
Input Settings
TAP TO CHANGE
THE SETTINGS
(→ Parameter table)
MORE SETTNGS ON
NEXT PAGE