Alarm Display; Cleaning Mode; Lock Mode - S+S Regeltechnik RYMASKON 700 Series Operating Instructions Manual

Operating instructions
RYMASKON ® 700 - BACnet
®
RYMASKON 700 - Modbus

ALARM DISPLAY

Accessing the
alarm notifications

CLEANING MODE

Activating
Cleaning Mode
(cleaning the display)

LOCK MODE

Activate the
display lock
LOCK MODE
Deactivated
Only ON / OFF
Only adjustment
No input
S+S REGELTECHNIK GMBH | THURN-UND -TA XIS - STR. 22 | D -90411 NÜRNBERG | GERMANY | FON +49 ( 0 ) 911 51947- 0 | w w w.S p lusS.de
Warnings on the unit can be accessed by tapping
the Alarm icon on the auxiliary screen.
NOTE:
If 'Bus' is set as the sensor source,
the alarm will be suppressed.
Typical causes of an alarm notification.
• External sensor 1 (RI1) error
(if activated but not connected)
• External sensor 2 (RI2) error
(if activated but not connected)
• Integrated sensor error
• Digital contact error
Cleaning mode can be activated by tapping the Cleaning icon
on the auxiliary screen.
The unit changes to the 'display cleaning' state,
all switching icons and buttons are disabled and
a 30 second timer is displayed.
The display can be cleaned during this time without
causing any unintentional entries.
Tapping the lock icon on the auxiliary screen, makes it
possible to lock the unit to prevent unauthorized access.
A PIN code can be defined to activate/deactivate the locking
state ('Lock Code', default: 0000 = no PIN required).
NOTE:
The display lock is also retained if the unit is switched off
and back on again.
The following configurations are available
(see table).
▲ ▼
PARTY ⁄
UP ⁄ OFF
LOCK DOWN MODE
– ▯ ▯
▯ ▯
–
▯ ▯ –
▯ – –
23
ACTIVE SWITCHING ICONS
ECO AIR CON
MODE FAN AC
▯ ▯ ▯
▯
– –
– ▯ –
– – –
Notifications
Internal Sensor Failure
External Sensor 1 Fault
External Sensor 2 Fault
Digital Contact Fault
Time Lost
Fig.14
30
Clean Screen
Fig.15
Lock Code
Enter Code
0000
7 8 9
4 5 6 -
1 2 3
Esc
0
Del OK
Fig.16
LIGHT BLIND
▯ ▯
▯ ▯
– ▯
– ▯