S+S Regeltechnik RYMASKON 700 Series Operating Instructions Manual page 17

Operating instructions
RYMASKON ® 700 - BACnet
®
RYMASKON 700 - Modbus
BLIND
CONTROL
Display and
settings
(2 zones)
S+S REGELTECHNIK GMBH | THURN-UND -TA XIS - STR. 22 | D -90411 NÜRNBERG | GERMANY | FON +49 ( 0 ) 911 51947- 0 | w w w.S p lusS.de
The switching icons on the main screen can be enabled to operate the blind zones (up to 2 zones).
The switching icons are enabled in the settings (display - function 1 / 2).
NOTE:
The Light, A ⁄ C Climate and Blind functions share two icon positions on the main screen.
If both blind zones are enabled, manual control of light and A ⁄ C (air conditioning) is not possible.
Tapping the respective icon means that the unit changes to the blind screen.
Depending on the configuration in the settings menu, an adjustment of the blind can be made on
the blind screen via the arrows with different step sizes and types of movement. The step size and
movement types can be configured as follows (Settings - Display).
Blind Mode (step size):
• 2 Positions (On/Off)
• 5 Positions (4 steps)
• 11 Positions (10 steps)
• Sliding / 1% steps (infinite)
The positions are distributed equally from 0 -100 %.
Blind configuration (movement type, graphical depiction):
• Translatory movement 'Level' (Fig.7a)
• Rotary movement 'Tilt' (Fig.7b)
• Translatory + rotary movement 'Level + Tilt' (Fig.7c)
BLIND SCREEN (display options)
Blind 1
Fig. 7a 'Level'
If one of the arrows on the Blind screen is tapped for a short time, the corresponding value (0-100%)
changes by the set step size. The value (position of the blind) can be accessed and changed via the bus.
If sliding step size is set, the control will behave via the display as follows:
• Short tapping of the arrow changes the corresponding value by 1%.
• Touching an arrow for longer than 0.6 s will change the value automatically and the
arrow can be released. The automatic change is stopped either by a short tap on the
arrow or reaching the min./max. value (0/100 %).
The last command to be issued applies. That means that if the position of the blind has been changed
via the bus, the user can change the mode value again and vice versa.
17
Blind 1
Fig. 7b 'Tilt'
Blind 1
Fig. 7c 'Level + Tilt'