Table of Contents
Advertisement
2.4.1
Connecting the ServeRAID-MR10i RAID Controller to Physical
Disks
2-8
Figure 2.4
SAS Plugs, SATA II Plugs, and SAS Backplane
Receptacle Connector
SAS Primary
Physical Link
SAS Secondary
Physical Link
Power
SATA II
Physical Link
This subsection provides step-by-step instructions for connecting the
ServeRAID-MR10i controller to the SAS physical disks and SATA II
physical disks.
Figure 2.5
from the controller to the physical disks.
Follow these steps to connect the ServeRAID-MR10i controller with
internal connectors to a physical disk.
Step 1. Plug the connector on the internal cable into the internal
connector on the controller.
Step 2. Plug the connector on the other end of the internal cable into
the connector on the SAS physical disk or the SATA II physical
disk.
Step 3. If you have another physical disk, connect it to another plug on
the internal cable.
ServeRAID-MR10i SAS/SATA Controller Hardware Installation
Serial Attached SCSI
Power
Serial ATA
shows how to connect the internal SAS cable
SAS Backplane
Receptacle Connector
Power
SAS Secondary
Physical Link
SATA II/SAS
Physical Link
Note: SATA II backplane connectors
do not accept SAS drives.
Primary
Advertisement
Table of Contents
