Setting Storage Expansion Unit Shelf Ids; Setting Exn4000 Or Exn1000 Storage Expansion Unit Shelf Ids; Setting Sas Expansion Unit Shelf Ids - IBM N6000 Series Installation And Setup Instructions

Setting storage expansion unit shelf IDs

Use these instructions to set the storage expansion unit shelf IDs.

Setting EXN4000 or EXN1000 storage expansion unit shelf IDs

A unique shelf ID (from 1 to 7) is required for each EXN4000 or EXN1000 in a loop.
Shelf ID 1 is used for the first unit in a new loop. Shelf IDs for additional units are incremented
sequentially from the number of the first unit.
To adjust the storage expansion unit shelf ID, press the - or + buttons.
Shelf ID - close-up view
Note: This illustration shows a detailed view of the EXN4000. The shelf ID buttons on the EXN1000 are
in the same relative position.

Setting SAS expansion unit shelf IDs

A unique shelf ID (from 00 to 98) is required for each SAS storage expansion unit in a SAS stack.
1
!
Figure 5. Shelf ID tab on the EXN3000
Mute button
Shelf ID
!
Gb switch
1Gb 2Gb 4Gb
(set to 2 Gb)
1Gb ELP
4Gb 2Gb
Installation and setup instructions
7