Table of Contents
Advertisement
1.7
Hardware Specifications
Step 4. Remove the SAS cable connectors from the internal drives that
you want to migrate.
a. Make sure that pin 1 on the cable matches pin 1 on the
connector.
b. Make sure that the SAS cables conform to all SAS
specifications.
Step 5. Remove the physical disks from the first system, and insert
them into drive bays on the second system.
Step 6. Connect the SAS cables to the physical disks in the second
system.
Step 7. Determine the SAS target requirements.
Step 8. Perform a safety check.
a. Make sure that all of the cables are attached correctly.
b. Make sure that the RAID controller is installed correctly.
c. Close the cabinet of the host system.
Step 9. Reconnect the power cords to the system.
Step 10. Turn on the power to the system.
The controller detects the RAID configuration from the configuration data
on the drives.
You can install the ServeRAID-MR10i controller in a computer with a
mainboard that has a PCI Express slot.
hardware configuration features for the ServeRAID-MR10i controller.
Table 1.3
ServeRAID-MR10i Controller Specifications
Specification
RAID Levels
Devices Supported per Port
Ports
Data Transfer Rate
Bus
Hardware Specifications
Table 1.3
describes the
ServeRAID-MR10i Controller
0, 1, 5, 6, 10, 50, and 60
Up to 15 SAS or SATA II devices (such
as physical disks and expanders)
Eight internal
Up to 3 Gbits/s per phy
PCI Express 1.0a
1-15
Advertisement
Table of Contents
