Internal Sas Cable For Connection To Sas Physical Disks Or Sata Ii Physical Disks - IBM ServeRAID-MR10i User Manual

2.4 SAS Device Cables
2-6
by the operating system manufacturer and to review the
readme file that accompanies the driver.
This section describes the cables used on the RAID controller and
provides step-by-step instructions for connecting SAS physical disks
and/or SATA II physical disks to the controller. The SAS protocols and
SATA II protocols use a thin, 7-wire connector instead of the 68-wire
SCSI cable or 26-wire ATA cable.
Note: Use only straight SAS cables, not cross-over SAS cables.
Figure 2.2 displays the SAS cable that connects the internal connectors
on a RAID controller to SAS drives.
Figure 2.2 Internal SAS Cable for Connection to SAS Physical
Disks or SATA II Physical Disks
Physical Disk
Connector
Figure 2.3 displays the SATA II device plug connector used to connect
a RAID controller with internal connectors to the host receptable
ServeRAID-MR10i SAS/SATA Controller Hardware Installation
Serial Signal
Cables
RAID Controller to HDD
Breakout Cable
4-Lane Internal
Connector
SFF 8484