Table of Contents
Advertisement
SECTION 4: OPERATIONS
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Operation
This downdraft table draws dust from the work
table into a two-stage filter system, virtually elimi-
nating dust from the air. The side panels can be
latched in place or folded down to make room for
larger workpieces. Dust is collected in a drawer
at the front of the machine and can be easily
removed for cleaning.
IMPORTANT: Two portable electric sanders can
be plugged in and operated simultaneously, but the
combined amp draw cannot exceed the following:
H2935 Maximum Amp Draw ................... 7 Amps
H2936 Maximum Amp Draw ................... 6 Amps
Model H2935/H2936 (Mfd. Since 06/16)
manual
BEFORE
To use downdraft table:
1.
Place panels in upright position and latch in
place; or fold panels down when sanding larger
workpieces that extend beyond the table.
2.
Plug a portable sander into one of two outlets
on front of downdraft table.
3.
Place workpiece on table, turn downdraft table
ON, and perform operation (see Figure 14).
Tip: Use power cord hanger (see Figure 14)
to keep long cords out of the way.
Cord
Hanger
Figure 14. Typical sanding operation setup.
4.
Turn downdraft table OFF when finished.
Resetting Circuit
Breaker
The machine is equipped with a reset button (see
Page 3) that allows the motor to be restarted after
the overload protection has tripped. To reset,
place the ON/OFF switch in the OFF position,
wait a few minutes for the motor to cool, then
press the reset button. If the button does not stay
depressed, allow the system to cool longer, then
try again.
-19-
Advertisement
Table of Contents
