Maintenance - Toro Groundsmaster 3320 Series Installation Instructions Manual

Maintenance

Adjusting the Rear-Cover
Latch
Adjust the latch assembly
does not seal properly or if it does not latch when you use
operate it.
Figure 25
1. Latch assembly
CAUTION
A raised hopper may not stay in the raised position.
Working under an unsupported, raised hopper may
result in a serious personal injury.
Never work on the hopper unless it is in the lowered
position.
General Practices
•
Keep the machine clean, checking that the engine is free
of dirt and chaff. Ensure that all fasteners are tight.
Check the deflectors, baffles, and shields for wear and
replace them as needed.
•
Remove the grass clippings from the hopper, chute,
blower, and cutting unit after each use. Wash the
underside of the cutting unit daily. An excessive buildup
of clippings will impair the performance of the collection
system.
•
Refer to the operator's manuals for the traction unit and
the cutting units for the service requirements of each.
(Figure 25) up or down if the cover
Lubrication
Service Interval: Every 25 hours
Grease the cylinder and all pivot points with No. 2 lithium
grease. There are 8 grease fittings at the various pivot points
and 1 fitting on each end of the cylinder
16
(Figure 26).
Figure 26