Toro Groundsmaster 3320 Series Installation Instructions Manual page 13

7
Installing the Front Blowout
Shields
Parts needed for this procedure:
1 Top shield
1 Wide shield
1 Narrow shield
1 Short flat
1 Short flat
8
Screw (#10 x 1 inch)
8 Flange nut (#10)
Using the Hopper with a 52-inch Deck
Note: The following instructions are as viewed from the
front of the machine.
1. Secure the wide shield to the left inside lip of the
hopper opening with a long flat, 3 screws (#10 x 1
inch), and 3 flange nuts (#10) as shown in
Figure 22
1. Wide shield
2. Long flat
3. Narrow shield
2. Secure the narrow shield to the right inside lip of the
hopper opening with a long flat, 3 screws (#10 x 1
inch) and 3 flange nuts (#10) as shown in
3. Secure the top shield to the upper inside lip of the
hopper opening with a short flat, 2 screws (#10 x 1
inch) and 2 flange nuts (#10) as shown in
Note: Use the 2 mounting holes on the right side of
the opening only.
Figure 22.
4. Narrow shield
5. Short flat
Figure 22.
Figure 22.
Using the Hopper with a 60- or 62-inch
Deck
Note: The following instructions are as viewed from the
front of the machine.
1. Secure the wide shield to the right inside lip of the
hopper opening with a long flat, 3 screws (#10 x 1
inch) and flange nuts (#10) as shown in
2. Secure the narrow shield to the left inside lip of the
hopper opening with a long flat, 3 screws (#10 x 1
inch) and flange nuts (#10) as shown in
3. Cut 1-1/2 inches of material off the bottom edge of
the top shield.
4. Secure the top shield to the upper inside lip of hopper
opening with a short flat, 2 screws (#10 x 1 inch) and 2
flange nuts (#10–24) as shown in
Note: Use the 2 mounting holes on the left side of
the opening only.
1. Wide shield
2. Long flat
3. Narrow shield
13
Figure
Figure
Figure 23.
Figure 23
4. Narrow shield
5. Short flat
6. Cut off 1-1/2 inches
23.
23.