Installing Undercarriage - USC SEED 16 Series Operator's Manual

1. Using a forklift, pick up the conveyor in the center. Move conveyor over the
assembled undercarriage centering it.
2. Remove the angle supports from the slide stops. Place the slide in between the
two slide stops. Re-install the angle supports capturing the slide.
Slide
Angle
Support
3. Using the lower arm pin, assemble the lower arms to the bottom bracket on the
conveyor. For the 20 and 25 foot conveyor, use the hole closest to the inlet end
and for the 30 and 35 foot use the hole farthest away from the inlet end.
30 and 35 foot
Page 18
Seed Series 16 & 20 Conveyor
INSTALLING UNDER-CARRIAGE
Slide
Stops
20 and 25 foot