Downcon Setting; Genlock - Panasonic AJ AJ-HDX900 Operating Instructions Manual

Chapter 7 Menu description tables

7-2-7 DOWNCON SETTING

Variable
Item
range
DOWNCON MODE SQUEEZ For setting the mode of the down converter
LT-BOX output signals.
S-CROP
C U F R
DETAIL ON For setting the detail function for the down
OFF converter output signals ON/OFF.
The down converter output signals contain
detailed components that are set during HD
signal processing. In this setting, these
signals overlap the detailed components
dedicated to the down converter outputs.
Even if this setting is turned off, it is
impossible
components
processing.
C U F R
H.DTL LEVEL 00 For setting the horizontal detail correction
:
level for the down converter output signals.
08
:
31
C U F R
V.DTL LEVEL 00 For setting the vertical detail correction level
:
for the down converter output signals.
04
:
31
C U F R
DTL CORING 00 For setting the noise elimination level of the
01 details.
:
15
C U F R
H.DTL FREQ. 1 For
:
frequencies.
3
1: 2.5 MHz
:
5 2: 3 MHz
3: 3.5 MHz
C U F R
2DLPF ON For setting the 2-D low path filter reducing
OFF cross colors.
ON: Cross colors are reduced.
OFF: Cross colors are not reduced.
C U F R
SET UP For setting the setup level for the down
For AJ-HDX900E 0% converter output signals.
For AJ-HDX900P 7.5% <Note>
When the system frequency is set to 50 Hz,
C U F R the setup level will be 0%.
The underlining in the variable range column indicates the setting in the preset
mode.
Remarks
to turn off the detailed
set during HD signal
selecting the horizontal detail
4: 4 MHz
5: 4.5 MHz
(continued)

7-2-8 GENLOCK

Variable
Item
range
GENLOCK INT
EXT
C U F R
GL PHASE HD SDI
COMPOSIT
C U F R
H PHASE COARSE –100
:
+000
:
+100
H PHASE FINE –100
:
+000
:
+100
Remarks
For setting the standard signals for
executing the GENLOCK.
INT: For synchronizing to the standard
signal within the unit regardless of the
signals that are input in the GENLOCK
IN connector.
EXT: For synchronizing to the standard
signals that are input in the GENLOCK
IN connector.
For selecting the output signals that lock
phases to the signals that are input in the
GENLOCK IN connector.
HD SDI:
For locking the HD SDI signals to the
GENLOCK input.
For the down converter output signals,
the start position of the video delays by
about 90 lines.
COMPOSIT:
For locking the down converter output
signals to the GENLOCK input.
For the HD SDI output signals, the start
position of the video gains by about 90
lines.
For making coarse adjustment for aligning
phases of the horizontal synchronization, for
executing the GENLOCK.
For making fine adjustment for aligning
phases of the horizontal synchronization, for
executing the GENLOCK.
7
105