Setting The Clock; Set The Time Zone - Panasonic Palmcorder IQ PV-D406 Operating Instructions Manual

Setting the Clock
Setting the clock is divided into three sections; Set the Time Zone, Set the Daylight
Saving Time, and Set the Date and Time. Please follow instructions in the order
Q)
©
- ==
PIENE Before you begin... =
Set the Time Zone * Connect the Palmcorder to a power source.
The Palmcorder is set to the Fastern * Set the POWER switch to VCR or CAMERA. Uu
Standard time zone at the factory. If you Note: D
live in a different time zone, follow the CLOCK SET menu disappears if, after =
steps below to change it. Then, when activation, CLOCK SET UP A, DOWN У or O
traveling, rather than resetting the clock to | DISPLAY buttons are not pressed within 30 o
the local time, you can simply set the seconds. :
appropriate time zone. The Palmcorder's clock may lose or gain up
to two minutes per month. Please adjust as
necessary (refer to page 13).
1 Press CLOCK SET UP А to display
the CLOCK SET menu.
Press UP A or DOWN Y repeatedly
to select ki HB e ld si cen TE from
the CLOCK SET menu.
SELECT: PUSH F/A KEY
SET : PUSH DISPLAY KEY
3 Press DISPLAY to display the
SELECT TIME ZONE menu.
C PACIFIC
HAWAN
MOUNTAIN SAMOA
SELECT: PUSH F/A KEY
SET : PUSH DISPLAY KEY
4 press UP A or DOWN Y repeatedly
to select one of the eight time zones of
the location where you are using the
Palmcorder.
5 Press DISPLAY to fix the Time Zone.
The CLOCK SET menu appears.
To exit from the CLOCK SET
Note:
11