Completion - Sub-Zero IW30LH Installation Manual

IN S TA L L AT I O N

Completion

D OO R T RI M I NS TA L L AT I O N
After the panels have been adjusted, install the decorative
side trim to the door/drawers. To install, start at the top and
align the trim with the front and rear flanges on the bracket,
then snap into place by pushing the trim toward the back
of the panel. Once the top is secure, continue the installa-
tion downward until the remaining trim is completely secure.
Refer to the illustrations below.
SIDE TRIM
Door side trim
SI D E T R I M I NS TA L L AT I O N
Install the decorative trim strip to the handle side of tall
and column models. The side trim snaps over the bracket
attached to the handle side of the unit. Refer to the illustra-
tion below.
Side trim
14 | Sub-Zero Customer Care 800.222.7820
FRONT
FLANGE
REAR
FLANGE
Bracket flanges
TO P TR I M IN STALLATIO N
Identify the top trim strips by the notch on one end at the
bottom; this trim strip fits on the hinge side of the unit.
Insert the outer end of each trim strip behind the vertical
side trim. Engage the snap in the plastic side bracket and
slide the panel as far to the outside as possible. Refer to the
illustration below.
Rotate the inner end of each panel into the side flange of
the center shroud, next to the water filter access door. Press
on the trim strip to snap into place. Refer to the illustration
below.
Inner top trim Outer top trim