Completion - Sub-Zero Designer Series Installation Manual

Undercounter wine storage

Hide thumbs Also See for Designer Series:

Use and care manual (100 pages)

Installation manual (60 pages)

Installation (2 pages)

Table Of Contents

Table of Contents

Installation

Completion

DOOR TRIM INSTALLATION

After the door panel has been adjusted, install the deco-

rative side trim to the door. To install, start at the top

and align the trim with the front and rear flanges on the

bracket, then snap into place by pushing the trim toward

the back of the panel. Once the top is secure, continue the

installation downward until the remaining trim is com-

pletely secure. Refer to the illustration below.

SIDE TRIM INSTALLATION

Install the decorative trim strip to the handle side of the

unit. The side trim snaps over the brackets attached to the

handle side of the unit. Refer to the illustration below.

Door side trim

Unit side trim

Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.

All other trademarks are property of their respective owners in the United States and other countries.

KICKPLATE INSTALLATION

The kickplate must be removable for service. The floor

cannot interfere with removal. Finger-tighten the adjust-

ment bracket nuts. Refer to the illustration below. Make

in-and-out adjustments, then wrench-tighten the bracket

nuts. Install the kickplate with the provided screws.

A decorative kickplate can be attached to the factory-

installed kickplate. The three rows of vented louvers

cannot be covered.

To install a decorative kickplate, remove the paper backing

from the magnets and attach the decorative kickplate to