Raider RD-ESC01 User Manual page 21

D. If the motor shaft is bent (do not align!).
E. If a short circuit occurs when the cable is connected.
F. When unsure or problems are not described here.
8. STORAGE
• Keep the machine away from children.
• Turn off the engine and unplug if the machine is not in use.
• Allow the machine to cool before storage.
• Do not store the machine in direct sunlight for long periods.
• Replace worn or damaged safety parts.
• Keep the machine in a clean, dry, dark and freezing place, protected from dust and water and
out of the reach of children. The ideal storage temperature is between 5 and 30 ° C.
• Use the original packaging for storage whenever possible.
• Cover the appliance with a suitable protective coating that does not retain moisture. Do
not use sheet plastic as a protective cover. The non-porous shell will trap moisture around the
machine, promoting rust and corrosion.
9. TRANSPORT
When moving the machine, the drum must be switched off and the aeration base raised as high
as possible.
• Turn off the engine and unplug. When transporting, be careful not to drop or otherwise hit
the machine. When transporting, the machine must be secured against sliding and rolling. Do not
place objects on the device.
• The drum may be damaged during transportation, for example on a hard surface, even when
the engine is switched off.
Therefore, set the working depth of the drum to the highest position during transport.
10. FAULTS AND WAYS TO CORRECT THEM.
The table below shows symptoms of faults and how you can help yourself if your aerator stops
working properly. If you cannot find and correct the problem by following the instructions in the
table, contact a Raider Authorized Repairer. Attention! Before you start troubleshooting, stop the
aerator and unplug the aerator.
Faults
The engine
does not start
Abnormal
sounds
Extraordinary
vibrations
Reasons
No electricity
Defective cable
Defective fuse/plug combination
Drum is blocked
Drum is blocked
Loosened screws, nuts
or other fasteners
elements
The cutting blades are
damaged or dull
Working depth is too large
The lawn is too tall
Removal
Check the connection to the network
Check the cable, plug it in, replace it if
necessary, or have it repaired by a qualified
person
Prepare for repair at an authorized workshop
Remove clogging
Remove clogging
Contact after sales service
Loosened screws, nuts
or other fasteners
elements
Replace with new ones
Set a lower working depth
Mowing the lawn before aeration
21