Maintenance Instructions - Raider RD-ESC01 User Manual

www.raider.bg
20
injury or death. Always follow the procedures and precautions in this guide.
WARNING! Before any work on the machine (maintenance, inspection, replacement of
accessories, service) or before storing it, ALWAYS shut off the engine, wait for all moving parts
to stop and allow the machine to cool down. Prevent accidental starting of the engine (unplug the
power supply). If the machine is equipped with a trigger key, remove it.
THESE WARNINGS ARE NOT REPEATED AT THE NEXT POINTS!
Always make sure that all nuts and bolts are tightened and make sure that the machine is in
good working order.
Keep the machine in good condition, if necessary, change the warning and instruction labels
on the machine.
Always make sure that the vents are kept away from dirt.
For safety reasons, replace worn or damaged parts. Use only original spare parts and
accessories. Parts that have not been tested and approved by the equipment manufacturer can
cause unexpected damage.
Repair and maintenance work, other than those described in this section, which are more
complex or require special tools, leave them to our authorized service facility.

5. MAINTENANCE INSTRUCTIONS

• Check the collection basket frequently for wear or damage.
• Always be careful when adjusting the machine to avoid getting stuck between moving sharp
edges and solid parts of the machine.
• If you are repairing the drum unit, keep in mind that although the power is turned off, the
blades can still move.
6. CLEANING
ATTENTION! Never spray or wash the product with water. In any case, do not wash the parts of
the machine not intended for use with water. Never use harsh detergents or solvents.
6.1.After each use, carefully clean the machine.
6.2. Do not allow the handles to be contaminated with oil or grease. Clean the handle with
a damp cloth washed in soapy water. Never use harsh detergents or solvents. This can cause
irreparable damage to the product. Plastic parts can be corroded by chemicals.
6.3. Wipe the product with a slightly damp cloth or brush.
6.4. Clean the machine cover, especially the vents.
6.5. If any part of the machine is cleaned with water or a damp cloth, etc., it must be completely
dry. The metal parts must then be lubricated against corrosion with a suitable protective oil. Make
sure that water does not flow inside the machine.
6.6. The potential damage to parts caused by corrosion cannot be assessed as a manufacturing
or material defect.
6.7. After use, clean the outside of the machine, empty the grass bin and shake it to remove
grass and other debris.
6.8. Clean the bottom of the aerator and all cylinders used.
6.9. Clean the wheels, clay coating can change the depth of cut.
6.10. Wear safety gloves when handling drums.
7. CORRECTION
Please seek authorized service in the following cases:
A. If a grass aerator hits an object.
B. If the motor stops suddenly.
C. If the bottle is bent (do not align!).