Table of Contents
Advertisement
RAEMet Meteorological Sensor (Optional)
If your AreaRAE Plus/Pro is equipped with a RAEMet meteorological sensor (P/N: C04-0970-
000), it is typically removed for storage and must be attached before using it.
1.
If the AreaRAE Plus/Pro is on, turn it off. (Never attach or remove the RAEMet sensor
without first turning off the instrument's power.)
2.
Lift up the weather-tight rubber cover, located at the end of the handle, to expose the
RAEMet receptacle.
3.
Align the RAEMet's connector plug with the AreaRAE Plus/Pro's receptacle using the
indexing key and slot as a guide.
4.
Press the RAEMet's base into place, and then turn the locking ring to tighten the
connection. Never force the connector in or out of the receptacle.
5.
Tighten the locking ring until the RAEMet sensor is firmly seated. Do not turn the entire
RAEMet sensor.
If the RAEMet and AreaRAE receptacle are not aligned properly, electrical connections will not
be made and the RAEMet sensor will not operate. Also, when the RAEMet sensor is not attached
to the instrument, make sure the cover is securely closed to keep moisture and debris from
entering the base.
AreaRAE
IMPORTANT!
115
User Manual
Advertisement
Table of Contents
