Hilti NURON TE 60--22 Original Operating Instructions page 12

▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 12
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless SDS­Max rotary hammer drill with pneumatic hammering mechanism.
It is designed for drilling in concrete, masonry, wood and metal. The product can also be used for light- to
medium-duty chiseling on masonry and surface finishing work on concrete.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Undercut anchors
The product is suitable for setting selected undercut anchors. Use only suitable setting tools!
For more information contact Hilti Service.
3.4 ATC 2
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the product will suddenly pivot about its own axis in the opposite direction.
ATC detects this sudden pivoting movement of the product and switches the product off immediately.
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
3.5 Active Vibration Reduction
The tool is equipped with an Active Vibration Reduction (AVR) system which reduces vibration noticeably.
6 English
1
Chuck
@
Depth gauge adjustment (accessory)
;
Depth gauge (accessory)
=
Function selector switch
%
Lock button for continuous chiseling opera-
&
tion
Control switch
(
Battery
)
Battery release button
+
Battery status indicator
§
Side handle
/
On/off switch
:
Button for half power
∙
Half-power indicator
$
Service indicator
£
ON/OFF indicator
|
2267487
*2267487*