Table of Contents
Advertisement
CPI SATCOM & Antenna Technologies
8)
Loosen the 3/4" nuts on the elevation adjustment rod, place inclinometer on
the angled reflector support tube, raise or lower the antenna to the new
elevation. Snug the 3/4" elevation nuts at this time.
9)
Peak the antenna signal by fine adjustments made in both azimuth and
elevation.
10)
Repeat step 6 for marking satellite location.
11)
Return antenna to primary satellite by aligning azimuth and elevation
pointers with the marks made in step #6. Tighten all adjustment hardware.
21
4096-224
1.8M SERIES 1184
Advertisement
Table of Contents
