Table of Contents
Advertisement
CPI SATCOM & Antenna Technologies
Positioner Assembly
Tab
[ 9, 10, 11 ]
4 places
[ 7 ]
# 10
Hardware
Cross Arm
Reflector Support Tube
[ 8 ] 4 places
Arm
Cross
14
STEP 12:
A). Remove (2) #10 screws and washers
from positioner assembly tab.
B). Attach elevation pointer (item 7) to tab
as shown with # 10 hardware.
C). Tighten only until lockwashers are
flattened.
STEP 13:
A). Attach reflector cross arms to the
reflector support tube with 1 / 2"
hardware ( items: 8,9,10,11). Do
not tighten.
Note the orientation of reflector
mounting holes, the inner most
holes on the cross arm flanges
will be to the top and the bottom
of the reflector.
4096-224
1.8M SERIES 1184
Advertisement
Table of Contents
