CONTENTS EU Directives and UKCA Standards..............3 Important Information and Health & Safety............4 Components for Evoflame & E-Smart..............5 Installation......................6 Model Dimensions..................7 Requirements and Checks................8 Installation....................9 Log Layouts......................11 Installing/Removing the Front Glass..............13 Troubleshooting....................14 Warranty &...
EU DIRECTIVES All Evonic Fires products meet the requirements of the EC Directives. All Evonic Fires products meet the requirements of the EC Directives. These directives have been met by compliance with the following standards: These directives have been met by compliance with the following standards: EU 2011-65/EU 2015/863 Restriction of Hazardous Substances.
IMPORTANT INFORMATION AND HEALTH & SAFETY When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: • Read all of the instructions carefully before using the appliance, only use this appliance as described in this manual.
INSTALLATION INSTALLATION REQUIREMENTS Before installing the appliance please read and take into account the following impor- tant requirements; • Consult a qualified professional to check the structure of the installation site. • The appliance must not be installed any- where that it may come into contact with water, i.e.
TOOLS REQUIRED • Tape Measure • Screwdriver • Pencil • PZ2 Screw Bit • Spirit Level INSTALLATION STEPS Remove the two bottom mounted transit brackets from both sides. You will not need these for the installation. Determine the finished height and position that you want the appliance to be located.
Page 10
Your plasterboard can now line up with the plaster kits on the edge of the appliance. Your installation is now complete and you can set up your logs. EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 DS ISS.
Page 12
LOG LAYOUTS When you have your appliance installed you can set up your log sets. If your model comes with Chippings, Glass Stones and/or Vermiculite lay this on the fuel bed first, then continue with laying out your logs. The following images show an example of how you could lay them out.
INSTALLING / REMOVING THE FRONT GLASS Unscrew and remove the glass retainer panel. Apply the Suction Lifter to the glass and place the bottom edge in first, then angle the top edge into the appliance. Then replace the top retainer panel. EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS.
Page 15
Evoflame Only - LED Strip Replacement Scan the QR code to be taken to a video in our maintenance series. Please note; this video shows an old method of removing the front glass panel. Refer to page 25 for the new method. Fan Re-setting &...
To receive your Extended Warranty your Evonic Fires product must have been purchased from an authorised stockist within our Retailer Network and your warranty registered with Evonic Fires through the online form - evonicfires.co.uk/register-your-product. The commencement date for the warranty period is the date of purchase.
Page 17
The Evonic Fires Extended Warranty does not affect your statutory rights. CK Fires Ltd / Evonic Fires 1, Evonic House, Clifford Park, Clifford Lane, Stratford-on-Avon, CV37 8HW Tel: +44 (0)1789 263868 Fax: +44 (0)1789 293080 Email: sales@evonicfires.co.uk www.evonicfires.co.uk Follow us on: Instagram | Facebook | Twitter | LinkedIn @evonicfires EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS.
Need help?
Do you have a question about the Stora DS and is the answer not in the manual?
Questions and answers