Table of Contents
Advertisement
Set-Up:
Power Supply
1. Before plugging your unit in be sure the source voltage in your area matches
the required voltage marked on your unit.
2. Do not attempt to operate this unit if the power cord has been frayed or
broken.
DMX Cable Requirements
This unit and your DMX controller require a
standard 3-pin XLR connector for DMX input
and DMX output (figure 1). If you are making
your own cables be sure to use standard two
conductor shield cable (This cable may be
purchased at almost all pro sound and lighting
stores). Your cable should be made with a male
and female XLR connector on either end of the
cable.
*Special Note: For reducing signal errors and avoiding signal transmission
problems and interference, it is always advisable to connect 120 ohm impedance
DMX signal cable and DMX terminator for signal connection.
MIDI Cable Requirements
The MIDI input will accept multiplexed digital MIDI control signal. The control
is via 5-pin DIN type connector. Pin connections are shown in figure 2. Another
5-pin DIN connector is also fitted for signal pass through, allowing the MIDI
signal to be fed through to other devices.
Data +
Figure 2
NC
NC
Data -
NC
Multi-Pak Instruction Manual Page 6
Figure 1
Advertisement
Table of Contents
