Related Manuals for Botex Multi Pack MPX-405
Summary of Contents for Botex Multi Pack MPX-405
- Page 1 English Professional Light Controller USER'S MANUAL Please read this manual carefully before use!
-
Page 3: Fuse Replacement
Unpacking: Thank you for your purchase of this Botex Professional product. Every unit has been thoroughly tested and carefully packed before delivery. Unpack the shipping carton carefully, check carefully for sure your new unit is not damaged and all accessories not missing. In the event damage has been found or parts are missing, please do not use it and contact your auth- orized dealer immediately. - Page 4 Functions & Controls (Front): MENU MENU MODE DISPLAY DISPLAY 1 CH. 2 CH. 3 CH. 4 CH. CHASE PROGRAM CHASE PROGRAM CHASE CHASE CHASE SPEED CHASE SPEED Receive Receive DMX Signal DMX Signal Parallel Parallel CHASE DIMMER CHASE DIMMER MIDI Signal MIDI Signal Chase Chase...
- Page 5 Functions & Controls (Rear): F6.3A 250V 5x20mm MIDI LINK EX. SENSOR THRU POWER INPUT:AC 230V~50Hz, 16A max 1=Ground 2=Data- 3=Data+ DMX IN DMX OUT 1. Power Cord - Plug this cord into a matching wall power outlet. 2. DMX Input - This connector is used to receive DMX input signal from a DMX controller.
-
Page 6: Power Supply
Set-Up: Power Supply 1. Before plugging your unit in be sure the source voltage in your area matches the required voltage marked on your unit. 2. Do not attempt to operate this unit if the power cord has been frayed or broken. -
Page 7: Chase Mode
Operating Instructions: This product has two different operating modes: Chase and Receive modes. In Chase mode, this unit serves as a 4 channel chaser. In Receive mode, this unit serves as a 4 channel DMX dimmer or MIDI pack. Please follow the instructions to operate the unit in your desired mode. -
Page 8: Receive Mode
Receive Mode: Use the MODE to access Receive mode, the LED near Receive is lit indicating your selection and the LED Display shows "CH" followed by two numbers from 01-16. This mode allows you to use your unit as a four channel DMX/ MIDI pack. You may also set your unit to function as a 1 or 4 channel pack. -
Page 9: Dmx Address Setting
In Normal MIDI mode, starting Note Number is exactly what you have selected in Note Number mode. For example, if you select 008, then it is the starting Note Number. In F36 mode, you must count the Note Number beginning from 36. For example, if you set 001 in Note Number, accordingly the starting Note Number should be 36, if you set 008, then the starting Note Number should be 43. -
Page 10: Mounting Options
Mounting Options: This unit has a sleek case design that makes it great for permanent or mobile application. Moreover, the back plate can be used to be removed and reversed. This function allows you to mount your unit to a tripod without the use of a clamp. To reverse the back plate, please follow the below procedures: Step 1: Use a screwdriver to remove the four screws... -
Page 11: Technical Specifications
Technical Specifications: Specifications: Power Input: AC 230V~50Hz, 16A Max. Power Outlet: One Schuko sockets per channel, total 4 output sockets DMX In/ Out: 3-pin XLR socket(male & female) MIDI In/ Thru: 5-pin DIN multiconnector Channel Fuses: One 6.3 A fuse per channel Accessory: Infrared remote control (sold separately) Size:... - Page 12 24-004-0515-00 Internet: www.botex.com Rev 2.2...