Raider RD-AC11 User Manual page 9

AIR CUT-OFF TOOL
RD-AC11
IMPORTANT:
Upon receipt of the product, read
and follow all safety rules, operating
instructions before first use it. And
retain this manual for future reference.
Contain:
Technical Data
џ
Important safety rules
џ
Operating Instructions
џ
Maintenance
џ
ТECHNICAL DATA:
Disc size:
3"(75mm)
Free speed: 18000rpm
Avg. Air consumption: 4cfm(114 l/min)
Operating pressure: 90psi(6.3bar)
Air inlet size: 1/4"
Air hose: 3/8" ID
A weighted sound pressure level:
96.9dB(A)
Sound power level: 107.9 dB(A)
Vibration in the handle: 2.0m/s
Important Safety rules
1. Always wear safety goggles or glasses.
2. Always ensure machine is switched off
before connecting to air supply.
3. Disconnect any machine from the air
supply before changing discs, and before
servicing any type of machine.
4. Always keep your air tool clean and
lubricated. Daily lubrication is essential to
avoid internal corrosion and possible failure.
5. Do not wear watches, rings bracelets or
loose clothing when using air tools.
6. Using only light weight coil hoses from a
tool to the wall or compressor coupling.
7. Do not overload the machine. Allow the
tool to operate at its optimum speed for
maximum efficiency.
8. Do not increase the air pressure above
the manufacturers recommended level, as
excessive overload can cause the machine
casing to split. Also this creates excessive
wear on moving parts and possible failure.
9. In the interests of safety and possible
damage to the machine/operator, always
ensure that the machine has stopped before
putting it down after use.
10. Always ensure that the work piece is
firmly secured leaving both hands free to
control the machine.
11. Always ensure that the accessories such
as discs. are rated/designed for use with the
machine. Also correctly and securely
fastened before connecting the machine to
the air supply.
12. When cutting always wear an
appropriate face mask or respiratory
equipment.
Operating Instructions
Description
Durable lightweight aluminum housing,lever
throttle for safety trigger , aluminum grip can
guard the sparkle,rear exhaust, built-in air
regulator for simple power and speed
control. Solid metal construction provides for
long tool life.To cut off mufflers and tail pipes
quickly and efficiently .
Air supply
2
1. Ensure air valve (or trigger) is in the "off"
position before connecting to the air supply.
2. You will require an air pressure of 90psi,
and an air flow according to specification.
3. WARNING! Ensure the air supply is clean
and does not exceed 90psi while operating
the wrench. Too high an air pressure and
unclean air will shorten the product life due
to excessive wear, and may be dangerous
causing damage and/or personal injury.
4. Drain the air tank daily. Water in the air line
will damage the wrench.
5. Clean air inlet filter weekly.
6. Line pressure should be increased to
compensate for unusually long air hoses
(over 8 metres). The hose diameter should
be 3/8" I.D.
7. Keep hose away from heat, oil and sharp
edges. Check hose for wear, and make
certain that all connections are secure.
7