Troubleshooting; Warning Signals - Barco Nio 2MP LED User Manual

Troubleshooting

7.1 Troubleshooting
General
If you experience trouble with the LCD display, refer to the following troubleshooting. If the problem persists,
please contact your local dealer or our service center.
Problem: No image appears on the screen
• Push the standby button.
• Check if all I/O and power connectors are correctly connected as described in the "installation" section.
• Make sure the pins of the connectors are not crooked or broken.
Problem: Partial image or incorrectly displayed image
• Check to see if the resolution of your computer is higher than the resolution of the display.
• Re-configure the resolution of your computer to make it less than or equal to the native resolution (1600 x
1200)

7.2 Warning signals

General
Sometimes you may see warning messages for this display. This means that the display cannot correctly
receive the signal form the computer graphics card.
Problem: No signal
This message means that the display has been powered on but it cannot receive any signal from the computer
graphics card. Check all the power switches, power cables, and video cable.
Problem: Out of range
This message means that the signal of the computer graphics card is not compatible with the display. When
the signal is not included in the compatibility mode we have listed in the appendices of this manual, the display
will show this message.
52 K5903058 /11 Nio 2MP LED Display