Connecting The Components; Before You Begin; Connecting The Components Of The Phone - Nortel NN43118-100 User Manual

Connecting the components

Connecting the components

Before you begin

Connecting the components of the phone

1. Attach the handset cord, with the longer straight section into the
handset jack on the back of the phone, then route the straight section
of the cord through the cord guide. Attach the other end of the
handset cord to the handset.
2. Thread the supplied CAT5-e Ethernet cable through the bottom of the
stand as shown in
power adapter, thread the cord through the bottom of the stand. If
connecting your PC through the phone, unplug its Ethernet cable
from the LAN and thread it through the stand. If using the optional
USB mouse or keyboard, thread its cable through the stand.
3. Connect the Ethernet cable from your data network to the RJ-45
connector marked
to the AC jack in the bottom of the phone. If connecting a PC through
the phone, connect the supplied Ethernet cable to the PC and then to
the RJ-45 connector marked
shown in Figure 6 on page 26
4. Attach the front edge of the stand by aligning the two clips on the
bottom of the phone with the matching pivot points on the stand.
Depress the tilt adjusting latch and push the stand firmly into the
phone in the direction illustrated as shown in
There should be two noticeable clicks when the stand is correctly
attached. Arrange the cords so that they exit from the rear of the
24
CAUTION
Damage to Equipment
Do not plug the IP Phone 2007 into a regular
phone
jack. This results in severe damage to
the IP Phone. Consult your system
administrator to ensure that you plug your IP
Phone into a 10/100BaseT Ethernet jack.
Figure 6 on page 26
. If using an optional AC power adapter, connect
. Plug in any optional USB devices as
.
. If using an optional AC
Figure 7 on page 26 .