Advertisement
Belt Replacement
REMOVE BELT
1
Lower deck to the LOWEST height of cut.
2
Remove belt covers.
3
Move idler arm to remove belt tension.
4
Remove belt from the PTO pulley.
5
Slip belt off - between pulley and belt guide.
4
3
6
1
5
4
3
2
1
+
2
3
4
5
INSTALL BELT
1
Slip belt on - between pulley and belt guide.
Note: After installing the new belt, check belt, guide gap
it should be approximately 1/8˝ (3.3 mm) away from belt.
2
Loop and hold belt around pulley while
3
- installing cover.
4
Repeat.
Place belt on the PTO pulley.
5
6
Move idler arm to remove belt tension.
7
Place belt on remaining pulley as shown.
3
2
5
14
1
1
4
7
6
Advertisement
