Advertisement
CYCLONE KIT ASSEMBLY - BOXING CHANNELS
NOTE: ONLY HORIZONTAL WALL SECTIONS ARE TO BE BOXED.
DO NOT SCREW ANY BOXED SECTIONS UNTIL THEY HAVE BEEN
ROOF SECTIONS, DOOR FRAMES AND UPRIGHT DOOR STUDS
USE SELF DRILLING TEK SCREWS FOR ALL ASSEMBLY
& INSTALLATION OF THESE SECTIONS
ALL SUPPLIED CHANNEL SECTION HAVE ONE
SIDE AT A LENGTH OF 38mm AND ANOTHER AT 40mm
SLIDE OPPOSING SIDE TOGETHER SO THAT
EACH CHANNEL FITS NEATLY
INSIDE THE OTHER
USE TEK SCREWS TO LOCK CHANNELS TOGETHER TO FORM A COMPLETED BOX SECTION AS SHOWN
ABOVE, ENSURE THAT YOU ALTERNATE TEK SCREW POSITION ON OPPOSING SIDE OF BOXED SECTION.
ALIGN TEK SCREWS 296mm APART, THIS IS APPROXIMATELY 2 SHEET CORRUGATIONS IN DISTANCE. IF
DONE CORRECTLY TEK SCREWS SHOULD LINE UP WITH CORRUGATIONS OF SHEETS ALLOWING FOR A
SMOOTH FLUSH FINISH TO WALL OR ROOF.
ABSCO INDUSTRIES
ASSEMBLY INSTRUCTIONS
CYC4560 CYCLONE KIT
CORRECTLY SIZED AS PER PAGE 13 & 14
ARE SINGULAR CHANNEL PIECES ONLY.
ASSEMBLY INSTRUCTION - MODEL: CYC4560 CYCLONE KIT 31/05/13
SLIDE THE 38mm SIDE INTO THE
40mm SIDE AS SHOWN
APPLY FIRM PRESSURE TO EACH SIDE OF THE
BOXED CHANNEL TO FIRMLY LOCK IT INTO
POSITION
PAGE 11
Advertisement
