N-Print Function - Hitachi LM-C300 Series User Manual

3.5. N-PRINT FUNCTION

By using the N-Print function, it is possible to print the number of times set by one sensor input signal.
For example, if the number of prints is set to 10, as shown in the figure below, you print 10 times with one
sensor input signal.
Touch Screen:
To use the N-Print function on the Touch Screen, follow the procedures below.
(1) Select "SETTINGS" on the main screen.
(2) Select "DYNAMIC & PHOTOCELL" at the top left of the screen. Select "Mode:" and select
"Dynamic distance".
(3) Press "BACK". Select "Signal" at the top left of the screen. Select "Trigger UP" or "Trigger Down".
(4) Press "BACK". Select "N-prints" at the top left of the screen. Enter how many times you wants to
print with one sensor input signal.
Laser Application:
To use the N-Print function using Laser Application, follow the procedures below.
(1) Go to the "Configuration" menu on the upper right edge.
(2) Select the "Dynamic and Photocell" option with the cursor.
(3) Select the "Mode:" and select "Dynamic distance".
(4) Select the "Signal:" and select "Trigger UP" or "Trigger Down".
(5) Select the "N-prints:" and enter how many times you wants to print with one sensor input signal.
(6) Press the "Apply" button to validate the changes and return to the main screen.
[NOTE 1] Even if the sensor input is ON until the Laser Marker prints the message the set number of
times, printing ends after the set number of times is printed.
Sensor
Print
[NOTE 2] If the sensor is turned off during printing of the set number of times and is turned on again
before the prints reaches the set number of times, the printing of the set number of times is
performed again from there. If there is chattering in the sensor input signal, the printing will
not be performed for the correct number of times, so avoid chattering.
Sensor
Print
Sensor
Print
- 46 -