Hitachi LM-C300 Series User Manual page 43

Laser Application:
To print a message with Laser Application, follow the procedure below.
(1) Click the icon
(2) A list of file names will be displayed. Select the file that contains the message you want to print.
(3) After checking the checkbox of "Layer" (upper left of the screen), change the print parameters
(speed, resolution, etc.) from "Properties" (lower left of the screen).
[NOTE] Depending on the version of the application, there may be an "Apply" button on this
"Properties" section. In that case, the change will be reflected by pressing this "Apply"
button.
(4) Press the icon
[NOTE] The button layout etc. vary depending on the application version. Please confirm the
details of each button in Help
(5) Press the "Testprint" button to perform test print. (Forced printing once)
[NOTE] First set the object to be printed and then press "Testprint". Printing is performed
immediately when "Testprint" is selected.
(6) Press the "Print" button to wait for a print trigger.
(7) When the printing process starts, the information box below opens. The total number of copies
currently printed is displayed in "Total".
(8) When the print trigger is input, printing will be started. Click the icon
printing process.
[NOTE] When the trigger is set to OFF in the item "Signal", printing is immediately performed in
"Printing mode active", and printing is not stopped unless the icon
. Or select the "File" menu and choose the "Open" option.
to open the dialogue below.
(6)
(5)
.
- 43 -
if you want to stop the
is pressed.