Hyundai HTRT65-2C Original Instructions Manual page 18

b. Cleaning the air filter
Use a compressor to blow dust and chips.
To clean the filter foam: open the air filter, remove the foam. Clean this foam with gasoline, wring
out and dry. Replace the foam in the air filter and reassemble as described in the diagram.
After 10 uses, replace the foam with a new one.
c. Cleaning the oil inlet
Disassemble the chain guide and the chain hood and check that the oil supply is clean. If dirty,
remove dirt with a clean compressor or cloth.
d. Cleaning the oil filter and fuel filter
Clean these items regularly. Remove them from the tanks using clamps. Clean them with gasoline
and then put them back in place afterwards
e. Guide bar
Cleaning: Remove bar guide to remove dirt from grooves and oil inlet.
Regularly grease the pinion.
Check: Reverse the bar from time to time to avoid the effects of wear. The bar rail should always be
in place. Use a ruler to observe it. If a gap is observed between them, then the rail is normal.
Otherwise, the rail is worn out. A bar must be corrected or replaced.
18