Hyundai HTRT65-2C Original Instructions Manual page 6

can be controlled by the operator, if appropriate precautions are taken. Do not allow the chain saw
to start.
Do not stretch the arm too far and do not cut above the shoulder height. This helps prevent
-
unintentional end contacts and allows better control of the chain saw in unforeseen situations.
Use only the manufacturers specified replacement guides and chains. Incorrect replacement guides
-
and chains may cause chain breakage and / or rebound.
- Follow manufacturer's instructions for sharpening and servicing the chain saw. A decrease in the
depth gauge level can lead to an increase in rebounds.
RESIDUAL RISKS
Even if you use this product in compliance with all safety requirements, the potential risk of injury and
damage remains. The following hazards may arise from the structure and design of this product:
• There are adverse health consequences resulting from the emission of vibration if the product is used
over long periods of time or not properly operated and properly maintained. Wear hearing protection.
• There is risk of injury and property damage due to sudden impact on hidden objects.
• There is a risk of hearing loss with prolonged use, especially if hearing protection is not worn. Always
wear hearing protection and limit the operating time.
• Cuts if no appropriate protective equipment is worn.
• Inhalation of particles and exhaust gases if no protective mask is worn.
• Risk of personal injury and property damage caused by flying objects.
• Prolonged use of this product exposes the operator to vibration and may produce "white finger"
disease. To reduce the risk, please wear gloves and keep your hands warm. If any of the symptoms of
"white finger" syndrome appear, seek medical attention immediately. Symptoms of "white finger"
include:
- Numbness, loss of feeling, tickling, tingling,
- Pain, loss of strength, changes in skin colour or condition.
These symptoms usually appear on the fingers, hands or wrists. The risk increases in cold weather.
SYMBOLS
Warning symbol
Read and refer to these operating instructions
Wear safety equipment that includes protective helmet, hearing protection and protective
goggles
Value of sound emission according to European Directive 2000/14/EC
The contact of the end of the bar with any object must be avoided.
Do not operate the tool with one hand. Always hold it with both hands.
6