Hyundai HTRT65-2C Original Instructions Manual page 16

CHECKING THE LUBRICATION OF THE CHAIN
Before checking the oil, make sure that the bar and the chain are in place.
-
- Once the engine is started, turns it at medium speed and checks that the chain oil is sprayed
and traces off the ground.
The oil flow of the chain is adjustable to obtain the proper flow. Insert a screwdriver on the
-
clutch side.
Turn the adjuster to obtain the correct flow rate for the job.
-
The chainsaw must essentially consume the contents of the oil tank between each full of fuel.
-
Do not forget to fill the oil tank when filling the machine with fuel.
RELEASE OF A JAMMED SAW
If the saw gets stuck during cutting, the operators should:
- Saw the saw and attach it securely to the cutting foot of the shaft (ie trunk side) or has a separate chord
from the tool
- Pull the saw of the cluster while the branch is lifted, if necessary,
- If necessary, use a hand saw or a second chainsaw to release the chain saw.
CUTTING WORK
The tool should only be used to cut trees. Do not use it for other applications.
Do not attempt to remove the chainsaw when it is stuck during operation. Stop the machine and remove
the wedge blade with a wedge.
Stick your feet well, keep a good balance and do not climb on the tree trunk.
Try not to work on a slope. However, if you have to work on a slope, always stand higher than the tree
trunk.
Before bending a branch or trunk in bending, observe the direction of bending and finish the cut opposite
the bending side to prevent the chain guide from getting stuck in the cut.
FELLING OF TREES
Examine the work area and estimate where the tree will fall. Start the machine as described above. Start by
making a notch in the direction of fall chosen.
When the tree falls, shout or make a beep to alert people in the vicinity. When the shaft falls, move away
from the cutting area.
a. Trunk on the ground
Cut half of the trunk, turn it over and finish the cut on the other side.
16