Connecting Leakage Sensor H2O; Plugging Leakage Sensor, Model 2605 - NetPing IO v2 User Manual

independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
Connecting Leakage Sensor H2O
To plug a sensor, there is a need to connect:
Colored Cable
Green
Yellow
Brown
White
Every sensor will be displayed in a device interface as a status of an IO line, to which it is connected.
Important! A corresponding IO line must be set to an "input" mode in settings of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of flat cable extenders of
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
Plugging Leakage Sensor, Model 2605
To plug a sensor, there is a need to connect:
Colored Cable
Green
Yellow/White
Red
Black
Every sensor will be displayed in a device interface as a status of an IO line, to which it is connected.
Important! Corresponding IO line must be set to an "input" mode in settings of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of flat cable extenders of
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
RC-4 sensor, which are sequentially plugged one into another. Or it can be done
RC-4 sensor, which are sequentially plugged one into another. Or it can be done
[ENG] NetPing IO v2, User guide -[ENG] [IOv2] Plugging Sensors
2
. Maximum allowable length of a
Contact Name
One of IO lines – 1 - 4
GND
+U
GND
2
. Maximum allowable length of a
Contact Name
One of IO lines – 1 - 4
GND
+U
GND
2
. Maximum allowable length of a
[ENG] [IOv2] Plugging Sensors
–