Plugging A Glass Breaking Sensor; Connecting Motion Sensor Swan-Quad - NetPing IO v2 User Manual

Table of Contents

Advertisement

independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.

Plugging a Glass Breaking Sensor

Surface security sound detector «Glass-3» is designed to detect breaking glass sheets. A sensor announces alarm by
opening contacts of executive relay.  A detector has a possibility to adjust sensitivity, to choose an operating
algorithm, light LED indication of a status of a detector with a possibility to switch indication off.
To plug a sensor, there is a need to connect:
Labelled (red) wire
First wire after a labelled one
Second wire after a labelled one
Third wire after a labeled one
Each sensor will be displayed in a device interface as a status of an IO line to which it is connected.
Important! A corresponding IO line must be switched to an "input" mode in settings of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of
flat cable extenders of RC-4
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
Connecting Motion Sensor SWAN-QUAD
To plug a sensor, there is a need to connect:
Colored Cable
Green
White
Black
Red
Every sensor will be displayed in a device interface as a status of an IO line, to which it is connected.
Important! A corresponding IO line must be set to an "input" mode in settings of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help
of flat cable extenders of
Flat Cable
sensor, which are sequentially plugged one into another. Or it can be done
Labelled (red) wire
First wire after a labelled one
Second wire after a labelled one
Third wire after a labelled one
RC-4 sensor, which are sequentially plugged one into another. Or it can be done
[ENG] NetPing IO v2, User guide -[ENG] [IOv2] Plugging Sensors
Flat Cable
2
. Maximum allowable length of a
Contact Name
+U
GND
GND
One of IO lines – 1 - 4
2
. Maximum allowable length of a
Contact Name
One of IO lines – 1 - 4
GND
GND
+U
[ENG] [IOv2] Plugging Sensors
                             – 

Advertisement

Table of Contents
loading

Table of Contents