NetPing IO v2 User Manual page 7

Event
Parameters of a device
are reset to default
values.
LEDs 1 and 2 correspond to Eternet-ports 1 and 2 respectively. If the Ethernet connection is established on the
Ethernet-port 1, LED 1 is active, if it is established on the port 2, then LED 2 is active.
Operation modes of LED 1 and LED 2
Event
Turning on a device.
A device is turned on, there is no activity on a
device.
A device received a package.
Back panel of a NetPing IO v2 device is shown on the picture below:
1 – +U (power), 2 - +U (power), 3 – GND (ground), 4 – IO 1 (input/output1), 5 – IO 2 (input/output2), 6 – IO 3 (input/
output3), 7 – IO 4 (input/output4), 8 – +3V3, 9 – GND (ground)
Between terminals, there is a jumper for resetting parameters of a device to default values. More detailed
information can be found in the section "Resetting parameters of a device to default values"
[ENG] NetPing IO v2, User guide -[ENG] [IOv2] Connectors and Indicators
Indication
LED blinks during the entire process of resetting values of parameters (5-10
seconds).
Indication
LED lights only when a connection is established on a
corresponding Ethernet port.
LED lights continuously while a connection is established
on a corresponding Ethernet port.
LED blinks once for each received package.
[ENG] [IOv2] Connectors and Indicators
–