No Identification Code Detected - AGFA Drystar 5301 XL Reference Manual

No identification code detected

This error message appears when the Film Identification tag is not readable.
There are two possible solutions for this problem:
Topics:
• Reload the current film pack or load another film pack
• Overrule the Film Identification tag of the film pack
Reload the current film pack or load another film pack
To reload the current or another film pack
1. In case the printer does not start printing after re-inserting a film pack,
first check if this film pack is inserted correctly.
If the printer still does not resume printing, the following message will
appear:
Remove and re-insert
film pack -including
protective sheet-
properly. follow
loading instructions
2. Open the input tray and check again if the film pack is inserted correctly. If
you re-insert the film pack, the printer will perform the same check
sequence until printing is resumed.
Overrule the Film Identification tag of the film pack
If the "Overrule RF-tag Reading" setting is active, you can overrule the Film
Identification tag setting of the current film pack. In this case you can
continue printing using a limited Maximum Density.
To overrrule the Film Identification tag of the film pack
1. In case the printer does not start printing after inserting a new film pack,
check if this film pack is inserted correctly.
If the film pack is inserted correctly and the printer does not resume
printing, the following message will appear:
Drystar 5301 XL, Drystar 5302 XL | Problem solving | 117
Note: Only your local service organization has the possibility to
enable the "Overrule RFtag Reading" setting!
3730D EN 20210520 0952