Table of Contents
Advertisement
Current Rating
4 Ampere
I/O Interface
3.3
LED Indicators
There are three LED indicators.
LED Indicators
System Power Indicator
Reset Indicator
System Power Indicator
Charging Status Indicator
System Power Indicator
UART
There are two UART (UART0 and UART1) consoles with USB to UART Bridge ICs on Genio 350-EVK. Users can
use these consoles for debug purpose. The connectors are Micro USB type.
Supports word Lengths from 5 to 8 bits with an optional parity bit and 1 or 2 stop bits
•
Supports baud rates from 110 bps up to 961,200 bps
•
FTDI USB to UART Bridge FT232RL
•
UART0
UART1
UART0
I2C
Four I2C buses (I2C0 to I2C3)
•
Supports Master Mode Only
•
Adjustable clock speed for LS/FS/FS+ mode operation
•
Supports 7-bit address
•
MediaTek Proprietary and
Confidential
System Power from Buck
Figure 3-2 Jumper Selection for System Power
Location
D1206
D1207
D1001
D1
D1206
Figure 3-3 Jumper Selection for System Power
CON461 (Micro USB)
CON462 (Micro USB)
CON461 (Micro USB)
Table 3-4 UART Ports
© 2022 MediaTek Inc. All rights reserved.
Unauthorized reproduction or disclosure of this document, in whole or in
part, is strictly prohibited.
Genio 350 Evaluation Kit Hardware User Guide
System Power from
Color
Green
Green
LED is off if reset signal is low.
Green
LED is on if system is on.
Red
LED is on while charging.
Green
Core Processor Log
DSP Log
Core Processor Log
Genio 350 EVK
Unclassified
Charger
Note
Page 12 of 24
Advertisement
Table of Contents
