Table of Contents
Advertisement
Telephone Helpline: 1300225960
Turn On
1. Ensure the power switch is set to [O] and turn
on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Control Panel
Set the Operating Temperature
1. Hold the SET button for 3 seconds. The value
of the current set point will be displayed.
2. Press the
or
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
•
The appliance will automatically run a defrost
cycle every six hours.
•
To manually defrost the appliance: Press
and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
Cleaning, Care &
Maintenance
Defrost appliance at least every 3 months,
more often if required.
Switch off and disconnect from the power
supply before cleaning.
•
Clean the interior of the appliance as often as
possible.
•
Do not use abrasive cleaning agents. These
can leave harmful residues.
•
Clean the door seal with warm soapy water.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
•
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
FA440-A to FA443-A_GH332-A to GH333-A_A5_v2_20211229.indb 5
FA440-A to FA443-A_GH332-A to GH333-A_A5_v2_20211229.indb 5
Stainless Steel Care
To maintain the stainless steel exterior of your Polar
item, please consider the following information:
Never:
•
•
•
•
Do:
•
buttons to display the
•
•
•
•
Routine Maintenance - Condenser
Cleaning
•
•
•
•
Note: Condensation will form in
refrigeration on hot humid days,
please ensure condensation is
allowed to drain properly or is
wiped dry.
Use abrasive Scourers or scrubbing pads, etc.
Use Chlorinated or acidic detergents
Allow anything e.g. food, dirt, cleaning
chemicals to remain on the surface for longer
than necessary, clean them off right away.
Allow the surface to remain wet.
Clean often.
Use soft Cloths or plastic Scourers.
Rub with the grain of the metal, rather than
across it.
Use detergents and polish designed for
cleaning Stainless Steel.
Ensure that the cleaning products are washed
off fully and that the steel is left dry.
The condenser is part of the refrigeration
system. The condenser requires monthly
cleaning.
Always disconnect power supply before
carrying out Routine Maintenance.
Failure to clean the condenser will reduce the
performance and life of your Polar unit and
may invalidate your warranty.
These models have a removable filter which
can be cleaned with a vacuum cleaner.
AU
5
2021/12/29 11:26
2021/12/29 11:26
Advertisement
Table of Contents
