Table of Contents
Advertisement
2-3. Replacement of Power Supply Unit
Installation
6. Installation of power supply unit/SW
cover
(1) Place the power supply unit in the chassis
with paying attention to avoid catching on the
harness.
(2) Place the SW cover on the power supply unit
with paying attention to avoid catching on the
harness.
(3) Adjust the location of screw holes and fix the
power supply unit with the four screws.
(4) Adjust the location of the SW cover by
aligning the slot of SW cover with the boss,
then fix the switch cover with the four
screws.
7. Connection of harness
(1) Connect the harnesses in the reverse order
referring to "3. Removal of harness".
However, refer to the following figure for
bundling the harnesses of fans 1 to 6.
. Connect the harnesses of fans 4, 5 and 6,
then bundle them with clampers.
. Connect the harnesses of fans 1, 2 and 3,
then bundle them with clampers.
2-24 (E)
SW cover
FAN 4
FAN 1
Clamper
Boss
Slot
FAN 5
FAN 6
Clampers
Clampers
Clampers
IF-715 board
FAN 2
FAN 3
Clamper
IF-715 board
Clampers
Clampers
BKNW-116
Advertisement
Table of Contents
