Table of Contents
Advertisement
3. Removal of HDD unit
Removal method varies according to the HDD
unit.
For upper part (HDD unit 1 or 2) ;
(The figure shows the removal of HDD unit 2.)
(1) Remove the SCSI cable from wire holders 1.
(2) Disconnect the two 68-pin connectors by
holding each end of it.
n
Never pull the covered wire.
(3) Open wire holder 2 and free the SCSI cable.
(4) Move the SCSI cable to the opposite side of
the HDD unit 2 as shown in the figure.
n
Place the SCSI cable gently so that the hard
disk drives do not receive any shock.
(5) Disconnect the three harnesses shown in the
figure from the IF-715 board.
(6) Free SE harness and UNIT harness from wire
holder 4.
BKNW-116
68-pin connectors
Wire holder2
Other harnesses are omitted in this figure.
SE harness
SCSI cable
HDD unit 2
2-2. Replacement of Hard Disk Drive
SCSI cable
Wire holder2
HDD unit 2
Wire holders1
POWER harness
UNIT harness
IF-715 board
Wire holder4
2-5 (E)
Advertisement
Table of Contents
