2-2. Replacement of Hard Disk Drive
2. Removal of hard disk drive
In this procedure, explanation is made assuming
that there are hard disk drives A and B in HDD
unit and A is to be removed.
(1) Open the wire holders of HDD unit and free
the harnesses.
(2) Place the HDD cushion at the edge of desk as
shown in the figure.
(3) Turn the HDD unit upside down and place it
gently as shown in the figure.
n
Put the edge of the HDD bracket to outside of
desk so that the hard disk drives can be
placed on the HDD cushion directly.
(4) Disconnect the harness from the connector
(8P) of the hard disk drive to be removed.
(5) Unscrew the four unify screws.
2-10 (E)
Wire holders
B
HDD unit
B6-32 (UNC)
HDD unit
Place the hard disk drives on the HDD cushion directly.
Wire holder
A
Hard disk drives
B6-32 (UNC)
HDD cushion
Harness
Connector(8P)
HDD bracket
BKNW-116