Shelf Operation; Drying In The Cabinet - Labconco Protector 34000 Series User Manual

Shelf Operation

The three drying shelves on the left side wall can be positioned horizontally to dry
small pieces of evidence, or swung down, against the left side wall of the liner, if
needed. To position the shelves in the up (horizontal) position:
1. Pivot the desired shelf until it is above horizontal (the frame of the shelf is
higher than the retaining clip on the back wall of the liner).
2. Push the shelf back all the way.
3. Slowly lower the shelf to a horizontal position, ensuring that the frame of
the shelf engages the retaining clip on the back wall of the liner. The shelf
is now ready to use.
To fold the shelf down (vertical position):
3. Lift up on the rear frame of the shelf, to release it from the rear retaining
clip.
4. Pull the shelf towards the front of the liner.
5. Allow the shelf to swing down into a vertical position.

Drying in the Cabinet

Start-up
 Ensure the drain strainer is in place.
 Turn the switch to "Fan".
 Check the condition of the prefilters. If your protocol requires the use of
evidence prefilters, ensure a new set of both door and cabinet prefilters has
been properly installed, according to the instructions in Chapter 6: Maintaining
Your Cabinet. Note if the Filter System light is on.
 Wash hands and arms thoroughly with germicidal soap.
 Wear a long sleeved lab coat with knit cuffs and over-the-cuff rubber
gloves. Use protective eyewear. Wear a protective mask if appropriate.
Product Service 1-800-522-7658
Chapter 5: Using the Cabinet
23