Preparing The Evidence Drying Cabinet For Operation - Labconco Protector 34000 Series User Manual

Preparing the Evidence Drying Cabinet for
Operation
After the evidence drying cabinet has been removed from its pallet and positioned
in its final location, you must:
1. Remove the tie and/or tape securing the door, the lower storage area door,
and the filters on top of the unit.
2. Ensure that the transport brackets have been removed from the front of the
cabinet liner.
Note: The following are located in a box in the lower storage space:
 User's Manual
 Power Cord
 Product Registration Card
 UV Security Lock Key(s) (model #s 34000-00 thru -04,
34040-00 thru -04 & 34050-00 thru -04 only)
 Drain Strainer Cup & Grid
 Rubber Drain Stopper
If you did not receive one or more of the components listed for the cabinet, or
if any of the components are damaged, contact Labconco Corporation
immediately for further instructions.
3. Using a step ladder, remove the tape and/or packaging material around the
top of the unit.
4. Plug the power cord into the back of the cabinet, and then into an
appropriate outlet. Install the Key into the UV Security lock on the upper
panel on those models equipped with a UV light.
Product Service 1-800-522-7658
Chapter 3: Getting Started
11